Heat pumps
AC repair
Furnace & heating
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateGoodman Heat Pump Service: The Summerlin Owner’s Guide
Goodman heat pump service in Summerlin typically runs $150 – $650 for the parts-and-labor work most failed components need, and we can often get to you the same day you call. We’re an independent service company, not affiliated with Goodman, but our technicians are trained on the brand and know its residential heat pump lines well. Most Summerlin owners find us the same way: a system that ran fine all cooling season starts short-cycling, blowing lukewarm air, or tripping the breaker on the first cold morning it has to run in heat mode. That switch from cooling to heating is when worn contactors, tired capacitors, and sticking reversing valves show themselves.
Which Goodman Models This Applies To
Goodman’s residential heat pump lineup covers the GSZ and GSX split-system families and the packaged GPH and GPC units, and the same part rarely fits across all of them. A run capacitor in a 2-ton GSZ14 is a different microfarad rating and physical size than the one in a 3.5-ton GSZ16, and putting the wrong one in is how you cook a compressor. The data plate inside the outdoor unit’s electrical panel is your ground truth: it lists the model and serial numbers, and the capacitor itself is stamped with its MFD rating and voltage. Photograph both before you call. Summerlin’s desert swings matter here too. Units that bake on a west-facing wall at 110°F age capacitors faster than the same part in milder climates, so the rating on the plate is not a suggestion.
On the OEM-versus-aftermarket question, Goodman’s own parts are solid, and quality aftermarket equivalents from established manufacturers meet the same electrical specs at a lower price. We’ll tell you plainly which is which on your estimate and let you choose. What we won’t do is drop a no-name capacitor in to save eight dollars.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Goodman Heat Pump Service Is Failing
- The outdoor fan runs but the compressor hums and won’t start. That’s usually a failed run capacitor or a pitted contactor. The compressor is trying to start on a weak jolt, and left alone it will eventually fail outright.
- The system trips the breaker in heat mode but cools fine in summer. This points at the reversing valve solenoid or its wiring. Heat mode reverses refrigerant flow, and a solenoid that won’t shift leaves the unit working against itself.
- Ice on the outdoor coil that never clears. A heat pump should defrost on a timed cycle. When the defrost control board or its sensor fails, frost builds until airflow chokes and the unit shuts down on a safety.
- Lukewarm air from the vents in heating mode. Often the auxiliary heat strip contactor or sequencer has failed, so the system runs on the compressor alone and can’t keep up on a cold Las Vegas Valley night.
- Short cycling every few minutes. Frequently a low-pressure switch tripping on a refrigerant charge issue or a clogged filter-drier. It can also be a failing thermostat, which is the cheap fix we check first.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Installed parts work in Summerlin falls in the $150 – $650 range for the common failures above. Here’s what moves the number:
- Run or start capacitor: at the low end, under $200 installed. The part is inexpensive; the diagnosis and safe discharge are the value.
- Contactor or relay: $180 – $320 installed, depending on whether it’s a single or double-pole unit and how buried it sits in the control box.
- Defrost control board or sensor: $300 – $500 installed. Boards are model-specific, which is why we match the exact Goodman series.
- Reversing valve solenoid or the valve itself: the top of the range, $450 – $650 when a full valve replacement is needed. This is refrigerant work, so recovery and recharge are part of the price.
Every quote is upfront and itemized, parts and labor separated. The price quoted is the price paid. The work carries our 90-Day Done Right Promise: if it’s not right, we make it right, in writing, no arguing. $50 off any repair over $250 applies, and seniors and veterans get 5% off.
DIY or Call Us?
You can safely check a few things yourself. Write down the outdoor unit’s model and serial from the data plate, photograph the capacitor rating, confirm the breaker is fully on, and change the air filter. That’s it, and here’s why. The inside of a Goodman heat pump holds a capacitor that stores a lethal charge even after the disconnect is pulled, and a compressor terminal or live contactor sits inches away. We’ve seen homeowners get hurt handling that panel, and we’ve seen good compressors destroyed by a wrong-MFD capacitor. This is electrical work around high voltage and refrigerant under pressure, and it belongs with a trained technician. Call us at (888) 325-9387 and we’ll handle the rest.
FAQs
Capacitors and contactors commonly last 5 to 10 years, while control boards and reversing valves often reach 12 to 15 before failing. In Summerlin’s heat, expect the shorter end of those ranges for any part mounted inside the outdoor cabinet, because constant 100°F-plus afternoons age electronics faster. A part that fails at year four is worth a look at the whole system, not just the replacement. Call (888) 325-9387 and we’ll give you a straight read.
Sometimes, yes. A pitted contactor can occasionally be cleaned and dressed, and a loose terminal is a reconnect, not a new part. Capacitors, boards, and reversing valves are replacement-only. We’ll tell you honestly which situation you’re in before any work starts, and if a cleaning fixes it, that’s what you pay for.
Most single-part replacements take 45 minutes to two hours, and the majority of Summerlin jobs are finished in a single visit. A reversing valve is the exception, since it involves recovering and recharging refrigerant, so plan on a longer appointment. We’ll give you a realistic window when you call rather than a number that sounds good.
We match the part to your unit’s exact model and serial off the data plate, then order the OEM number or a cross-referenced aftermarket equivalent. That model-specific match is what prevents the wrong-size capacitor or board from going in. We also service Carrier, Trane, and Lennox systems the same way.
When your Goodman heat pump needs a part, you want one call that ends with it fixed and a written guarantee behind it. Fireside Heating & Air Co. answers the phone with a live person around the clock, quotes upfront, and sends background-checked, uniformed technicians who’ve handled Goodman equipment for years. Our technicians have up to 8 years of experience, and most jobs are done in one visit. Call (888) 325-9387 for a free estimate, and we’ll be there when we say.
Written by the team at Fireside Heating & Air Co. Summerlin, serving Summerlin and nearby areas.