AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Ductwork Repair: The Summerlin Owner’s Guide
Ductwork repair on a Lennox system in Summerlin typically runs $350 to $1,400 installed, depending on whether the fix is a sealed joint, a reconnected run, a replaced section of flex duct, or a full trunk line rebuild in an attic that bakes at 140°F. We handle most isolated ductwork repairs the same day, and every job is backed by our 90-Day Done Right Promise. You’ll know something’s wrong before you see it: rooms that won’t cool no matter where you set the thermostat, a utility bill that climbed $60 to $90 in one summer, or dust on the furniture two days after you cleaned. In Summerlin’s newer builds, the telltale is often the upstairs hallway that runs hot at 4 p.m. while the downstairs stays comfortable.
Which Lennox Models This Applies To
Ductwork is the part of the system that isn’t branded, but it does have to match your Lennox equipment’s airflow specifications. That covers the whole Lennox residential lineup we see across Summerlin: the Merit series (13ACX, ML14XC1, ML17XC1), the Elite series (EL16XC1, EL18XCV), the Dave Lennox Signature Collection (XC21, XC25, SL28XCV), plus the matching gas furnaces (ML180, EL280, SL280V) and air handlers. What matters for ductwork is the air handler’s rated CFM output and the static pressure it’s designed to run at. A Lennox 3-ton unit moving 1,200 CFM needs duct routing sized for that volume. If a prior contractor undersized a return or pinched a supply run during a remodel, the equipment will short-cycle, freeze the evaporator coil in summer, and wear the blower motor out early. We measure static pressure at the air handler on every ductwork call, and we’ve found readings 0.3 to 0.5 inches of water column over the Lennox spec on plenty of Summerlin jobs.
To identify what you have, look at the data plate on the indoor air handler or furnace, usually inside the closet or attic. The model number tells you the cabinet width and CFM rating. Take a photo of that plate before you call. The other checkable detail: measure the return air grille. A 3-ton Lennox system should have at least 400 square inches of free return area. Many Summerlin homes built in The Ridges and Red Rock Country Club during the 2000s were fitted with a 20×20 grille on a system that needed a 20×25. That single mismatch, more common than you’d think in Red Rock Country Club, is a $200 to $400 fix that prevents a $2,000 blower replacement down the road.
On the OEM versus aftermarket question: Lennox doesn’t manufacture ductwork, so there’s no “Lennox-brand” duct section to hunt down. What you’re matching is duct material and gauge. For supply and return trunks in a Summerlin attic, we use R-8 insulated flex duct or 26-gauge galvanized sheet metal sealed with mastic, not foil tape alone. Cheap aftermarket flex with R-4 insulation will sweat and fail in our climate. Fireside is an independent service provider and is not affiliated with Lennox.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Ductwork Repair Is Failing
Ductwork fails slowly, then all at once. Here’s what to watch for:
- Rooms that never reach the thermostat setpoint. This usually traces to a disconnected flex run or a crushed duct in the attic, and it’s the most common call we get in Summerlin during July and August. If one bedroom runs 6 degrees warmer than the rest of the house, the supply feeding it has almost certainly come loose at the collar.
- A whistling or rushing sound at the return grille. That’s high static pressure caused by undersized return duct or a partially collapsed flex line. On a Lennox variable-speed air handler, the blower ramps up trying to move air it can’t get, which is hard on the ECM motor.
- Dust settling on furniture within a day of cleaning. Return-side leaks pull attic insulation fibers and dust into the airstream, then push them out the supply registers. Every one of those particles is also air you paid to cool.
- Visible condensation or water stains at the air handler closet or ceiling. In Summerlin’s low indoor humidity, this usually means a supply duct is leaking cold air into a hot attic and sweating, or the insulation jacket has degraded. Left alone, it rots the surrounding drywall and framing.
- A bill that jumped without a rate change. Duct leakage of 20 to 30 percent is common in homes twenty years or older, and a 30 percent leak on a Lennox system rated at a 14.5 SEER2 delivers something closer to 10. You’re paying for cooled air that’s ending up in the attic.
Replacement Cost & What’s Included
Here’s what ductwork repair runs in Summerlin, installed:
| Repair Type | Installed Price |
|---|---|
| Sealing disconnected or leaking joints (per run) | $150 – $350 |
| Replacing a single flex duct run (supply or return) | $250 – $500 |
| Replacing a section of rigid trunk line | $400 – $900 |
| Return air plenum or transition rebuild | $350 – $800 |
| Whole-home duct seal and static pressure correction | $600 – $1,400 |
Where your job falls in that range depends on attic access, how much of the system needs work, and whether we’re dealing with flex or rigid metal. Our price is quoted upfront and it’s the price you pay. We pull the existing section, install R-8 insulated flex or 26-gauge galvanized where it belongs, seal every joint with mastic, and check static pressure at the air handler before we leave. The work is covered by our 90-Day Done Right Promise in writing, no paperwork and no arguing if something isn’t right. Calls are answered by a live person, 24/7, so you won’t be routed through a voicemail tree when your AC quits at 10 p.m. on a Sunday in Summerlin.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely do a few things yourself. Check that all your supply registers are open and unobstructed. Look at your filter (a clogged Lennox filter is the single most common cause of low airflow, and swapping it is a five-minute job). Feel around the air handler closet for obvious gaps where ductwork meets the unit. Take photos of anything that looks off.
What we’d urge you to leave alone: anything involving the attic. Summerlin attic temperatures routinely hit 140°F to 160°F from May through September, and heat stroke happens fast up there with no warning. Reconnecting a duct collar, re-taping a joint, or re-routing a run means climbing joists, working around electrical and gas lines, and resealing under negative pressure. It’s a job that goes wrong when it’s rushed, and a botched return can starve your compressor and turn a $300 repair into a $2,000 problem. Our technicians are background-checked, uniformed, and trained as journeymen; our technicians have up to 8 years of experience, and every one of them treats your attic the way they would their own mother’s. If in doubt, call (888) 325-9387.
FAQs
R-8 flex duct in a Summerlin attic typically lasts 10 to 15 years, less if it’s R-4 or was installed near a hot roof deck. Rigid galvanized trunk lines last 25 to 30 years but only if the joints stay sealed. UV exposure, attic heat, and rodents are the three fastest killers here, and rodent damage on attic duct is something we see every week in Summerlin.
Often, yes. A single disconnected run, a crushed section, or a plenum gap can usually be repaired without touching the rest of the system. We won’t quote a full replacement if a $250 to $500 repair solves it, and we’ll tell you plainly when replacement makes more sense. Straight talk, not a sales pitch. Call (888) 325-9387 for a free second opinion on any written estimate you already have.
A single run or plenum repair takes 1 to 3 hours, and most of our Summerlin jobs are done in a single visit. A whole-home seal or multi-run replacement takes 4 to 6 hours, occasionally spilling to a second morning if attic access is tight.
We source duct material through HVAC supply houses to match your Lennox air handler’s rated CFM and cabinet size, not from a generic stock list. Fireside carriers fits R-8 insulated flex, 26-gauge galvanized sheet metal, and code-compliant mastic for every job. We don’t claim to stock parts on a truck – the material is ordered to fit your specific system. Call (888) 325-9387 to schedule and we’ll come measure.
Ready to Get It Right?
Fireside Heating & Air Co. Summerlin has been serving homeowners across Summerlin for over 42 years, and we service Lennox systems alongside Carrier and Trane every week. If your Lennox ductwork needs attention, call (888) 325-9387 for a free estimate. We’ll put on shoe covers, give you a straight answer, quote a fair price, and stand behind the work in writing for 90 days. Done right, or we make it right.
Written by the team at Fireside Heating & Air Co. Summerlin, serving Summerlin and nearby areas.