Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Heating & Furnace in Summerlin: What to Know First
We provide independent Lennox heating and furnace service in Summerlin, and most repairs are finished in a single visit. Furnace repair typically runs $150 – $700, and you’ll know the price before we start. The price quoted is the price paid. We’re not affiliated with Lennox, so we have no reason to sell you a part you don’t need.
This page is for the homeowner whose Lennox furnace has been keeping the house warm for fifteen or twenty years, who wants straight talk about what’s wrong, what it costs, and whether it’s worth fixing. If that’s you, call (888) 325-9387. A live person answers, day or night.
How Lennox Products Fail – and How We Fix Them
Lennox builds good equipment. But every line has its habits, and after years of working on Lennox furnaces across Summerlin, we know which ones show up in the truck bay. Here’s what we actually find.
- Ignitor failures on the G61V and similar variable-speed furnaces. The silicon nitride ignitor takes the worst of the winter duty cycle. In Summerlin’s dry air you’ll often get a hairline crack you can’t see without a meter, and the furnace locks out cold with no flame. We test the ignitor under load rather than guessing, because a weak gas valve or a dirty flame sensor can mimic the same symptom.
- Inducer motor bearings on mid-efficiency Lennox units. The draft inducer spins every call for heat, and the bearings dry out and start to whine or grind, usually in the first cold snap after a long idle summer. Ignore it and the pressure switch drops out and the furnace shuts down. We pull the assembly, check for debris in the flue, and replace the motor rather than nurse a bearing that’s already talking.
- Cracked heat exchangers on older Lennox furnaces. On furnaces past fifteen years in Summerlin, we see stress cracks and corrosion along the exchanger seams. That’s a safety issue, not a performance one, and we won’t seal it and send you back upstairs. We scope it, show you what we find, and give you a written opinion on repair versus replace.
- Flame sensor soot and nuisance lockouts. Lennox flame sensors foul faster when a home has poor combustion air or a dirty filter habit. The furnace lights, runs a few minutes, then drops out and retries. A five-minute sensor clean and a combustion check usually settles it, and we’ll tell you honestly when it’s the sensor and when it’s telling you about a bigger problem.
- Control board and gas valve faults on older Signatures and Elite series. Intermittent heat on a Lennox that should be running, often a tired gas valve or a board with a failing relay. We test the valve electrically before condemning it, because boards and valves both cost real money and we’d rather be sure.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Lennox Heating & Furnace Process
Here’s how a Lennox heating call runs from the moment you phone us to the moment we carry the last tool out.
- 1
We answer. A live person picks up, 24 hours a day, every day. We’ll ask what the furnace is doing and book a window that works for you.
- 2
We diagnose before we quote. Our background-checked, uniformed technicians go through ignition, combustion, airflow, and the control sequence. They test with meters, not guesses. Shoe covers go on without being asked.
- 3
We explain your options plainly. You get an upfront price before any work begins. Where there’s a choice between an original Lennox part and a quality aftermarket part, we lay out the trade-off: fit, cost, and warranty implications, and let you decide.
- 4
We do the repair. Most jobs are completed in a single visit.
- 5
We test and show you. We run the furnace through a full heating cycle, check combustion and temperature rise, and show you the readings.
- 6
We stand behind it. Every job is covered by our 90-Day Done Right Promise. If it isn’t done right, we make it right, in writing, no arguing.
See the difference
Before
After
Before
After
Before
AfterWhat Lennox Heating & Furnace Costs in Summerlin
Honest ranges, based on what we actually charge in Summerlin homes. Your exact price depends on the part, the furnace age, and how accessible the unit is. We give it to you upfront, free, before we touch anything.
| Job | Typical Range |
|---|---|
| Furnace repair (ignitor, sensor, inducer motor) | $150 – $700 |
| Gas valve or control board repair | $150 – $700 |
| Seasonal furnace tune-up and safety check | $80 – $200 (or $89 standing offer) |
| Air conditioning repair (for the cooling side) | $150 – $650 |
| AC installation (when you replace the whole system) | $3,500 – $7,500 |
What moves the price: the part itself, the furnace model, and whether it’s a heat exchanger job or a simple component swap. We carry $50 Off Any Repair Over $250, and a Free Second Opinion on Any Written Estimate. Call (888) 325-9387 for an exact quote. Estimates are free.
Why Summerlin Homeowners Call Fireside Heating & Air Co. Summerlin for Lennox Work
We’ve been serving homeowners for over 42 years, and a lot of that time has been spent on Lennox equipment in Summerlin. Our technicians have up to 8 years of experience and are trained on nine major brands, so when a Lennox furnace needs a tricky call, we’re not guessing at the first time we’ve seen one. We also work on Carrier and Trane, among others, which means we can give you an honest read on what your Lennox really needs, not what’s easiest to sell.
The guarantee is our word in writing: 90 days, done right, or we make it right, no arguing. We answer the phone when you call, including the 2 a.m. no-heat night. And we treat your home like our mother’s.
FAQs
Will a repair affect my Lennox warranty? It depends on the part and the age of your furnace. Original Lennox parts keep your existing manufacturer warranty intact; some aftermarket parts don’t. We’ll tell you which is which before we order anything, so you can protect the coverage you have.
Can you get Lennox parts in Summerlin fast? For common parts like ignitors, flame sensors, and inducer motors, usually yes. We’ll give you a straight timeline on the call and let you know if it’s a next-day part. No surprises.
Should I repair or replace my Lennox furnace? If your furnace is past fifteen years, has a cracked heat exchanger, or has had multiple repairs in one season, replacement is usually the honest answer. If it’s a single component and the rest is healthy, repair is worth it. We’ll give you the numbers on both and let you decide. Call (888) 325-9387 for a free second opinion.
How fast can you come out for a no-heat call? A live person answers around the clock, and we’ll tell you honestly when we can be there. Call (888) 325-9387.
Do you service Lennox systems you didn’t install? Yes, we work on Lennox systems we did not install. We’re an independent Lennox service provider, backed by our 90-Day Done Right Promise on every job.
Written by the team at Fireside Heating & Air Co. Summerlin, serving Summerlin and nearby areas.